carb elect.choke
 

:dunno:Can anyone tell me how to test and connect this item to the switch.

You can just hook it to a twelve volt battery, if you can't get the wires out of the plug safely you will have to splice them. Hook one side to pos, and the other to ground and measure how far the needle extends. It should extend about 3mm, and the unit should be a little warm.

Now what switch are you talking about?

The ignition just ground and 12v

one lead connects to ground, the other to which ever post on the ignition switch supplies constant 12 volt when the switch is in on position.

Say thanks mine is missing.Found it dangling.Hole where it goes is plugged with a bolt and silicon.Will start and run but takes a long time and a long time befor the throttle will work.