American Sportworks Helix Service Manuals
6 Attachment(s)
Attached below are the service manuals for the American Sportworks Helix (Model 6150).
|
a,ready seen em lool
|
Thanks, these will really help me out.
|
Is the GY6 150cc the long case or short case? Specifically the one in the Fox Helix.
Did they use both types? How do you know which one you have? |
anyone have any suggestions for performance parts to put on my stock helix 150
|
taitethomas, what kind of riding do you mostly do? Generally slow with a lot of hills or more wide open throttle in wide open fields or something?
|
little bit of everything. i run it on the road quite a bit so i like the speed. having the acceleration wouldnt be bad. i do go on some trails..haha not very specific am i?
|
Help!
I purchased an after market GY6 engine to replace the engine on a chinese scooter, but the wire colors and connectors do not match those on my scooter. What can I do?
|
helix
Quote:
|
You Are A GOD
:hooaray:
Quote:
|
spark plug
am i crazy or blind, I cannot find the spark plug on the Helix 150. Help!
|
lost sp plug ,,hahahhaha
kneel down on right hand side .lean over right rear wheel,directley undre gas tank,locate cylinder head,the plug is on the right side of the cylinder head,aboult 4 inches back at a 50 dgree angle,,never heard of not being able to find the plug OMG,i find it funny sorry,
|
do it
Quote:
|
So, I have the same scenario. No spark. It never ran. I just got it. I have been doing a 3 day long trying to figure out where the black/red and Blue/yellow (from strator) go. It cranks and only a few times it started but doesn't keep running. I have a DC CDI. The blue/white is connected via bullet connector to the blue/yellow. Does the black/red go to CDI? I clipped all the "kill switches". I have checked all voltages. Can the cdi intermittently work? I also cleaned and sandpaper the contact on strator. I hope I don't look like trolling. The OP is closest I found to same. I was told it runs I haven't been with any luck. I just purchased a new cdi/spark plug wire but the cdi was AC not DC. So I still kept the spark plug wire.
|
Blk./red wire is not connected. Are you sure it is a spark problem and not a fuel problem?
|
No fuel problems. Getting fuel. Confirmed it via spark plug hole. So, I do not need the black/red wire hooked to anything? Only the blue/yellow that connects to blue/white coming from CDI? I am just ruling out electrical.
|
The blk./red wire was used on the old ac system. Scroll to top of page and download the electrical manual and it will give you steps to trouble shoot.
|
Quote:
|
You have to read the t/s section for ignition. It says the b/r wire is not used for the cdi, it is used for testing purposes only. Read the instructions carefully for it tells you hoe to check with a volt ohm meter.
|
All times are GMT -5. The time now is 11:19 AM. |
Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.