Rear Axle for sale
1 Attachment(s)
This is out of the Sunl 150-SGA single seater.
Axle looks to be beefier than any i've seen, way better than the spiderbox piece. Includes the hubs, rotors, sprocket and bearings. I have the bearing case (somewhere) that's not on the left side. I would say it's an automatic that the bearings themselves should be replaced. $100 for it all plus shipping. Best way would probably be to ship as a box (hubs, rotors, sprocket and bearings) and a separate cardboard tube for the axle. Ships from easton, pA 18040. |
Quote:
|
i'll part it, not set on selling as a whole. I'll run the numbers on the bolt pattern and axle dia/spline count. I also have the bearing hangar plates with the caliper mounts on them as well as the calipers.
|
That's a beefy axle !!
|
yep, if you've got a yerf and want to swap out to something better, this be the puppy!
|
Quote:
|
That was my first thought too.
|
Axle overall is right around 42 1/4" long. Sprocket is off center at 20 1/4" -- 22" measured at the center of the teeth.
The studs can be knocked out and flipped so the sprocket can be put on the other side of the hub --there is a clean land of the same diameter so it would still be hub-centric. That would move the sprocket to 19 1/2" -- 22 3/4". Ckau -- hubs are 4 x 137. I have the rear rims on the rockhound. If anyone wants the hub bearing land location measurements, lmk. If i had this in hand, i never would have gone with the golf cart axle setup. I think i got it about 2 weeks after i made the golf cart swingarm. |
Quote:
|
All times are GMT -5. The time now is 07:12 AM. |
Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.