Info help
 

murray kilowatt 6.5 tec motor

what is the rpm of the 6.5 tec

i found new hubs for a 4" circle bolt pattern cani use atv or golf cart rims

if my info i was looking at is right its 3000 rpm and 4x101 rims any one know if thats right which if i put the 12" golf cart rims and a 12/48 gear it will go 27mph by the speed cal on diy go karts

Pretty sure max rpm is 3,500. Did you acutually count the rear axle sprocket? (48t seems small) I was thinking the stock tires on the rear were 8 X 18" or 19", so if you go taller the speed will increase but bottom end will lag. Mine gps'd @ 34 mph (only change was 6" driven) Can't confirm the 4 X 101, I believe it's a 4 X 110 and it's the same as Yerfdog,Manco and Honda -You can always redrill the hubs for 4 X 4" or if wheels are aluminum redrill them.

top govern speed 3,750 from the Tecumseh spec's

well the plans are golf kart or atv rims and shocks the 12/48 gear set is good for speed but i would never be able to get up and down hills so im going to have to find a happy middle

I actually used a set of golf cart 8" steel wheels back when and had to cut the center ring bigger to fit and re drilled the bolt pattern-they worked till i found some nicer wheels! I can't remember-are the hubs round or an "X" shape on the Kilowatt? if they're round just move to the center of the stock bolt pattern and re-drill them, golf cart wheels seem to be always available cheap and Polaris rear wheels use that same bolt pattern as well as Northern tools wheel set up's.Is the 12/48 what's on the kart now?

no the cart is bone stock still has the belt im going to buy the chain set up im planing on buying the hub upgrades off this website http://willardssmallengines.com/shop...ubs/page1.html they have everything