mikuni carbuator
 

I was wondering if this mikuni carburetor would work with a hammerhead 250 with 250 main jet and 40 pilot jet here is the link to the carburetor itself http://www.leatherup.com/p/Street-Bi...Fag7Ogod0zQA8g
Thanks in advance a mikuni vm30-83

jets you're not going to know til you stick it on and run it. it should be a good top end power carb, don't think you'd want anything bigger on a 250. I dropped down to a 24 flatslide from a 26 roundslide (old suzuki 250) to enhance the bottom end. lost 10-15 mph up top but got what i need down low.

www.sudco.com

chad's the mikuni man at sudco, best person to talk to about setting these up, especially if you pick it up through them if ya know what i mean.

Ok thanks for the advice i will buy one

I think I'll eventually get a Mikuni for my 150. Too much invested in the pumper at the moment though.

Good to hear. How is your 150 treating you on the trails?

I like it. I can really hammer it through trails, my only gripe being with the suspension. I'm going to invest in some custom Works shocks.

o ok sounds good... my problem is im 6 feet and 180 pounds so i need the independent suspension on the 250 to get me up the trails... i be mudding a lil bit to so i need something with a lil power