Rear sprocket swap
Going to upgrade to the 39T sprocket. How hard is it to do? I'm assuming I can figure it out once I get in there but any tips or tricks would be helpful to make it a smooth swap. Thanks
|
What buggy? You will need to either add to your chain or replace with a longer one.
|
Hammerhead 150.....I have new chain.....Just getting some info before I start anything.
|
You basically have to pull the rear axle. Not a difficult job, just remove parts. Bearings are not pressed on but have a snug fit onto axle.
|
All times are GMT -5. The time now is 02:11 AM. |
Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.