How to route fuel line on predator
 

Hello,

Back again. I have a yerfdog 3000 something cart that my kids ride. I was having problems with the carburetor jets getting clogged so I thought hey just install an inline fuel filter. I removed the gas tank from the predator motor and added an inline filter and a few more inches of fuel line. Now I can't ANY easy way to route the fuel line back with a gravity fed system. Having a hard time just figuring out how to run the line back the way it was without the fuel filter. Seems like the fuel lines get pinched between the tank and block or flywheel cover. Any suggestions on how it's supposed to get routed withouth getting pinched or hanging up with the throttle and idle springs. Even better would be a picture of how to route the fuel line with inline filter on a gravity setup.

Thanks!

MB

This is interesting. I ran into a little bit of this last night on my project with the fuel line. I hope it does not become a problem, as it sounds like it has the potential to.
My gravity fed fuel system's line runs right next to one of the engine's throttle mechanisms.

You can check out where I just installed a Predator 420 on a Yerf Dog 3206:

http://www.buggymasters.com/forum/showthread.php?t=5993

Feedback welcome :)