Hey, robby. When you took the cam out or more importantly put it back in, did you get your pushrods in correct? I can tell you from experience that generally speaking if your lifters/pushrod assemblies dropped out, they rarely go in correctly from the bottom easily. What I usually wind up doing is pulling the valve cover off (just a few simple bolts), taking the rocker arms off, putting the cam/lifters in, then finally put the pushrods in properly from the top. Set your lash to about .003.
I have a feeling what's going on is your push rods came out of their slot. Pull that valve cover off and turn it over. You should see the valve action move smoothly. Video it if you have to so we can see.
|