Yes the BS stage! Never ending.
Today I did the following:
Finished the exhaust mounts.
Cleaned up the wiring and tied it into the Dazon wiring. Only 2 wires between engine and chassie.
Mounted fuel pump, replaced all the fuel & Vaccume lines from car to tank.
Mounted voltage regulator, CDI unit.
Turned engine over and verified that it had spark and the kill switch was wired correctly. Not running yet, though.
Repaired the cooling air ducting around the cylinders.
Installed a new belt.
Hooked up the throttle cable, made sure it opened up all the way. Made the mount for it.
Things to do now:
Need larger fuel shutoff valve for tank.
Frame needs modified so that the pull start can be put back on it.
Fix Flat tire.
Charge battery, cause the stator will not charge a dead battery.
Get a Unifilter to fit it.
Figure out the mix ratio for the gas/oil.
Find that exhaust wrap so it does not burn my seats.
... Tomorrow will be a new list of course!
Also I think I am going to leave the Phazer alone until I need the engine, it runs so I am going to ride it a little.
What do you think of these plans
http://cgi.ebay.com/ws/eBayISAPI.dll...m=330637614208