[terrys]

Ok I got the harbor fraight motor in today. it started on the third pull. Runs great. looking at the belt it doesent look like it is ligned up perfectly. I may need to do some shimming. My question is about the two sprockets. They are not straight up and down with each other. The driver and driven seem to be straight up and down or on the same angle just not in line with each other. I can fix this. the sprokets are what i can not figure out or fix. It would look some thing like this.
\ -top small sprocket
|-large bottom sprocket
I have looked at it for hours and still cant figure out how they are not ligned up correctly. what could cause them to be out that way. all bearrings in the jack shaft are good and the large sprocket is not bent. Could the frame be bent somewhere getting the axle and sprocket out of lign with the jackshaft sprocket?
Thanks for the help.