latest pics ....
a-arms ready to be redone ... i think they looked like this back in november ...
messing with the shock mount boxes, they fit pretty nice in the plate gap. not going in this position though, bottom tab was just in the way ...
finished first arm ...
basic setup with the lower and "new" rim set at wheel height. with me in it, it should give about 11-12 inches of clearance to the back underside of the mount box (lowest front point). Nice amount of offset to the rims. tie rod alignment is going to end up about dead center between the arms.
Figured out the upper shock mounts tonight. going to have to jig a good flat piece of the top angle iron to make sure i have these square and on center to the arms when i weld them in since the tubes they attach to are going on different convergent angles ...
|