I own a "B" model gy6 and have had some difficulty getting the Hammerhead exhaust to fit.......it never did and is now on my Hammerhead Twister.
The aluminum intake also did not allow for enough clearance for the velocity stack to bolt on without hitting the engine carriage bolt on the bottom and the frame above the carb.......but using the stock manifold which is aluminum covered (not just rubber as suggested in some articles which sell the improved cast manifold)
Once my MRP exhaust arrives I hope it will fit and I can once again enjoy the buggy.
As far as the suspension goes .....I am thoroughly satisfied with the ride ......quite comfortable and very stable thru the whoops!
I hope this will help you decide.
Feel free to PM me if you have any further concerns!
Redfishlost
|