Quote:
Originally Posted by T3beatz
hey Ckau, what did you use to drill out your Hubs to mount on the 3/4" step down on the 1" axle.
Right now I'm debating on doing that or just buying a set of the 1" keyed hubs from bmi with the 4x4" bolt pattern. I Think I have a set of rims with that bolt pattern that will fit my tires. http://www.*************/item/4-x-4-W...wn-260053-5972
the hubs don't look too heavy duty, but I'm sure I can add a few gussets to stiffen them up a bit.
|
A 3/4 drill bit. The bore in the stock yerf hub is 3/4. The bit just knocks off the splines for a smooth bore. A dril press works best but you can do it with a hand drill if you hold the drill lightly and allow the bit to follow the bore.