[T3beatz]

I think this is the hub you split open.. http://www.*************/item/4-Bolt-...ub-AZ2286-5767

this one is the actual wheel hub that I linked. http://www.*************/item/Wheel-H...ore-260050-762 I plan on adding gussets on the back side to beef it up. but that's only if I go with that cheap axle...
I'll probably just bite the bullet and go with the 42" flexproof with these hubs.. http://www.*************/item/4-x-4-W...wn-260053-5972 only if BMI carried the flex proof axles in stock! I can save on the shipping.

I would use the stock hubs and just do it the way you did but I have a set of 4x4" rims laying around that should fit my tires. I also don't own a 3/4" drill bit and a new one cost about $20 bucks, add that to the cost of the keyed couplers and that's about $50 bucks extra, when I can just get the hubs for $15 bucks each from BMI.

Oh yeah, BTW, turns out those shocks on the front of your single seat buggy your building are not bad at all... I don't know if you checked out my thread but a simple mod makes them much better.

T.J.