Just got back from the Buggy Bash and it was a blast! the Axle held up perfectly, Nothing went wrong, not one tool had to touch my buggies rear end! If you have ever been to St. Joe state park you know that some of the trails there are not easy and if your buggy is not built strong it will break apart... my brother learned this, he still has the stock front ball joints and as we were loading up to go we noticed that one of his has completely pulled out from the tabs!
I did have a minor roll over and pulled a side of the factory welds apart on the rack, but 10 mins with a welder and it was good as new.
Soapkart was there and we all took a long ride at dusk on one of the longer trails in the park (the perimeter trail), it took us about 30+ mins to get through it.
T.J.
__________________
T.J.
Yerfdog Spiderbox, Uni Type air filter with 6" intake, 130 jet, Orange no-rev limit cdi, Red coil, iridium plug, 1500rpm clutch springs, 1500rpm contra spring, 13g sliders, 22" rears, 21" fronts, aftermarket reverse installed, and Trailtech Vapor.
|