I would go with 5/8" to 3/4" ones. either one should be strong enough for the swing arm, Just depends on how beefy you want it to be.
http://www.ebay.com/itm/1-2-x-5-8-18...84d922&vxp=mtr
http://www.ebay.com/itm/Panhard-Bar-...ht_3370wt_1397
if you go with 3/4" you may want to get the reducer to 1/2"
http://www.ebay.com/itm/3-4-1-2-REDU...ht_2371wt_1397
Your gonna need to either rebuild the old mounts or just use spacers to keep the heims centered. Your gonna have to cut the old bushing mounts off the swingarm, and get the correct ID tubing to weld the bung to.
@Kel, I would do the front end first, get the heims up there... and just go the least expensive route on the swing arm for now... then move to that later.
__________________
T.J.
Yerfdog Spiderbox, Uni Type air filter with 6" intake, 130 jet, Orange no-rev limit cdi, Red coil, iridium plug, 1500rpm clutch springs, 1500rpm contra spring, 13g sliders, 22" rears, 21" fronts, aftermarket reverse installed, and Trailtech Vapor.
Last edited by T3beatz; 07-10-2012 at 01:42 PM.
|