[KI4UJO]

Here is what I have done so far / know of as of now:
Replacement carb (Which was included when I did an engine swap in 2011)
5 Month Old Wiring Harness
Replacement CDI
2 Day Old Fuel
Adjusted Valve Tolerances to .005

Here is where I am lost: Being a Honda clone, I am familiar with it from working on it from ATC 110's. However, following everything that I have found online, I still can not get this to run right. Basically, it is very hard to start, and will not stay running when started. If I do get it to run, it generally bogs down after a few minutes. I do have a choke resistor on order, and it will arrive soon (Hopefully). In the mean time, what am I missing? I highly doubt that it is an electrical issue, as I have went over the harness several times trying to find any loose/bad connections.

All assistance is greatly appreciated.

Thanks in advance