Masteryota, I did my boxes with the ones from BMI, because the way they are made I had to do things a little bit differently than what ckau did. Mine works pretty good, but it doesn't look as clean as Ckau's. I had an old spiderbox swingarm in the shed that I wasn't using so I did the mod on it and it turned out pretty good. The only downside is I cant remove the bolts that hold the brake caliper on. I can remove the caliper but the screws are boxed in. I used 1 x 1.25 square tubing if I'm not mistaken, it's the same as the tubing that is on the swingarm now.
__________________
T.J.
Yerfdog Spiderbox, Uni Type air filter with 6" intake, 130 jet, Orange no-rev limit cdi, Red coil, iridium plug, 1500rpm clutch springs, 1500rpm contra spring, 13g sliders, 22" rears, 21" fronts, aftermarket reverse installed, and Trailtech Vapor.
Last edited by T3beatz; 05-20-2013 at 07:26 PM.
|