Quote:
Originally Posted by liduno
Should look killer.
I was a little worried about your center of gravity but then remembered there was no engine or driver in it..lol Worse case scenario, you could just raise the top shock mounts to lower it. Easier than making it wider.
|
shock mounts can't go any higher or the hub sprockets will snag the drive chain run. Everything suspension-wise front and rear on this puppy is constrained down to about 1/4 inch. 10-inchers really pushed it to the limit of what i've built. 8.5s would've been the better choice, but i couldn't pass on the price on the 10s.