Changed plug. Ran even better. Could even start without hitting gas. But was low rpm. Still spit gas out of carb at lower rpm. But did not at higher rpm. Opened up top of carb to lower the needle. Then noticed the cable going into carb. In side the carb. The throttle cable was very heavily frade. So bad I couldn't get cable out of carb. Had to cut it. Also, while doing this, the needle fell into my hand. Got top half of carb apart. The clip that holds the needle was loose. Pinched it so was tight again. But now half to replace the throttle cable. There was a brand new throttle cable, still in package that came with buggy. So this issue was known by previous owner.
Any hints or tips to install the new cable?
|