Almost done with the cover for the control center up front. Will line the inside of it with something, since fabbing it out of thin gage steel. It make it less conductive. Any suggestions? Going to be alot of wire splices in it.
At first had the white box turned long ways towards the seat. Then noticed that it could hit the frame behind the seat, if shocks came all the way down. So had to turn it.
Had just 2 tabs on the rack for gas tank. But then realized be to damn hard to line everything up straight, trying to make 4 tabs that line up perfect. So again started over, and had some round tubing. And welded one piece for each side, to very back of rack, and bottom piece. Now can use the full area of rack again.
|