I've been waiting for compressed air and a flywheel puller. I can say for sure that there is no way I would have gotten the flywheel off without the puller.
There was red clay in every crack and crevice..
I was impressed how clean this looked -
Clutch
Basket?
I can't get over how clean the internals look despite there being loads of sediment in the bottom of the crankcase. I had to stop here because I don't have the clutch nut wrench or socket.
I would make one but for $9 I'll have one come in the mail on Saturday.
This was the hilight of the evening - I decided to drain the gear oil. Closer to the consistency of slime.
I have nearly all the parts for my extreme budget engine build. Just need to source a carb. Only going to do 61mm piston, ported head, opened up exhaust. Any recommendations are welcome. Only requirement is that it has to be dirt cheap.