Quote:
Originally Posted by olderthan
looking good
|
Thanks
Quote:
Originally Posted by chuckorlando
The stock down bar right next to the seat and the one that runs from the pan around for the stearing... Notch a tube to go from the lower corner on both and up to the center of the upper bar. That way as the frame flex's down in the center it will transfer the pressure down and into the cage. Then if you got the steel run from the center ,or close to it, of the top bar and run one up to the windsheild area.
|
Sounds like a good plan.
Something like this?
Last edited by Kartjet52; 02-10-2013 at 08:27 AM.
|