The belt is at the top before you start it, but then it pulls it down. I found that in the manual there is a special section for the clutches on these and there are shim's that you have to remove as the belt gets narrower. I removed both shims even though the belt is at 1-1/8" wide (in the middle of the 1.02 & 1.25" manual spec) and it does the same thing. It just seams that the secondary will split apart with very little preasure. I tried a shorter (1") belt from my Phazer and it is 1/8" wider and it did the same thing. plus due to the belt being so tight, it would barely run.
Is it possible that I have got the gear ratio really screwed up? Or does it just need the lowerer rpm spring in the primary clutch?
__________________
2012 Polaris RZR570 stock!
|