I admit my video skills suck. I have 1 3/16" (w) belt, yes I have narrowed it since I started this. With the clutch fully open and the belt in there, I have about 3/16" to 1/4" of room between the sheve and the belt.
I did figure out something here a few minutes ago. The motor mounts were stretching when you gave it gas. So I removed the rubber mounts and put bolts through with washers as spacers. This caused the belt to be to tight so I backed off the tensioner to loosen it up to where the engine would idle and tried it again. It was the same story but not quite. When I shut it off and was waiting to put the cart back in the garage, I heard and saw the primary clutch slip out a little. I am wondering it the clutch is hanging up now or if the clutch is just junk?
Also arffter this run the belt was all the way out on the secondary.
I will post a better video tomorrow.
__________________
2012 Polaris RZR570 stock!
Last edited by 300cpilot; 01-07-2012 at 06:30 PM.
Reason: cause
|