Thanx for the bigger pics.The belt will be 3/4"-7/8" wide,5/8" would be when it's wore out!!! It appears you have a comet/or similar 30 series CVT,asymmetrical type belt system. You need to measure at the clutch shaft (part on the left or on the crank shaft of engine) to the outer rim of the driven unit. There should only be a small amount of play at the clutch (bottom of the pulleys).This is assuming you couldn't get the measurements from the link I gave you.
Last edited by metalstudman1; 06-18-2011 at 03:56 PM.
|