Getting ready to weld the steering shaft.
Steering extension completed.
I've had this laying around the garage for years, it's a steel door from an electronics cabinet. I'll be using it for the new floor....it's slightly thicker than what was there.
Need ideas on the extra supports for the lower frame. I painted the yellow lines where I think might be good reinforcement. I want to try to keep it simple yet safe. Let me know.
As far as progress goes, everything except the roll bars have been welded, welds just need to be cleaned up.
I cut the new floor from the door.
Installed the longer steering shaft. With it being 7" longer it feels a little flexy, I believe it'll be fine....If not i'll extend the steering hoop.
I also ordered a set of oil filled coilovers from Surplus center, they were less than $12 each. Figured i give 'em a try, if they work out good i'll replace all the mechanical shocks on both carts.