250 Muffler
Posting this for frame n things ...
Muffler originally from a HH 250SS.
As built it had two internal rods that held the caps together. tail end had internal bosses that the rods threaded into, pipe end the rods came through and the nuts on the end clamped everything together.
When i got it, the internal bosses were stripped, (common problem with these) so i drilled them out and ran threaded rod stock through the tail end and double nutted both ends. Has held together fine since then.
I removed the flex pipe and added a short tube stub. ID is 1.6ish"
I use 1.5" od pipe with a sleeve and a clamp.
If you have any interest in a trade, lmk, you can post pics in here, i also need to know the ID of the headpipe on your muffler to make sure it will fit.
As far as how loud it would be compared to yours, i have no idea. Internally, it has two drilled baffle plates and a center tube with spark arrestor/baffle grid a couple inches long. I haven't changed anything inside. There was no other packing inside it--nut sure if it originally had glass or steel wool inside it.
|