View Single Post
  #197  
Old 01-11-2018, 10:30 AM
Pripyat Pripyat is offline
Contributor
 

Join Date: Aug 2017
Posts: 143
Default

I'm feeling like I made negative progress today. I was going to swap out the rollers but the rollers in the known good engine were unevenly worn.



The six of them weighed 77g or approximately 12.8g each.

I didn't want to put the unevenly worn rollers in the engine I'm working on so I put some 11g sliders in that I ordered a while back. The rollers I pulled out weighed exactly the same as the the known good engine. 77g for the six.



I loosened the carb and reset it as it looked like the rubber boot wasn't perfectly straight. I also put the clutch assembly from the known good engine into the one I'm tinkering with. Also swapped back to the original exhaust.

I didn't get to do a plug test due to time constraints but I did get a significantly higher speed than I've been getting. Average in the straight was 33mph. Weird.



I'm not sure if it was the clutch, sliders, or me finangling with the carb. Sigh.

Last edited by Pripyat; 01-11-2018 at 07:24 PM. Reason: False info, weights corrected.
Reply With Quote