ok I think this is the last little hiccup here and idk if this belongs in this thread but I will try here. The only issue I have left is that my brake light switch isn't working. There may very well be something I missed when I installed. I bought a new master brake cylinder slapped it on when I got it, bled the brakes this morning using a mightyvac the brakes are working pretty good but one of the main reasons I got the new master was that I thought the brake switch was funked on the old one, I noticed the old one had teflon tape on the threads of the switch screwed inside the master. What the previous owner had done was take both of the ring terminals that go on the switch and put them on one post so that they are in constant contact. I really don't wanna do that because it causes my brake light to be on all the time. I would like for it to function right. I'm gonna post this in another thread too. Thanks guys!
|