good question Snap, I don't remember!
I belive the yerf stock wheel base is 42" if memory is correct . I use 9" wide rear wheels with a 6/3 offset so my wheelbase is somewhere around 52". I do remember wanting to stay under the maximum 54" wide wheel base allowed in state parks at that time.
Pete, I had considered your suggestion before but I doubt a locking collor would tighten the hub base enough. there"s no room to compress unless I split the hub center. What I want/need is something like this. I can find them with the 1" center but the total hub sizes are always too large to fit the 31 tooth yerf sprockets. I have bought several different variations, taperd sleaves, etc hoping to find one that can be modified but no luck yet. I did find one with the right dims. but after recieving the hub it was so cheezy and poorly cast I didn't bother trying it.
I probably should start another post on this subject as I don't want to stray from Snap's original questions.
I hear ya Tom! Nothing better than good pratical solutions!
