Just thought I would start a thread on my tube bender project. It's not a buggy thread but thought someone might find it interesting.
I decided to try and build a bender using the plans from gottrikes.com. I'm sticking pretty close to the plans with just a couple adjustments. So far the project is going well. I've been able to get all the pieces cut & drilled so now it's time to put it together. I'm hoping to get that done this week. I did have to go to the local shop and have a couple holes drilled as I didn't have an 1 3/8 bit.
Anyways, here's a pic of my pieces minus a few nuts & bolts. Hopefully I'll have a pic of them welded together by the end of the week.
http://www.gottrikes.com/Tube_Bender.htm