Little update. Started working on control panel up front. Think might be best location. Just tacked now. Will be a few inches higher, in final placement. Checked clearance for me, wife, and kids. Driver and passenger side. Seems good. In final product will shave down brackets so not sticking out, and no sharp edges.
Got light bar mounted. And ran the power inside the upper roll bar, leading down to front of buggy. Got all my trail tech wires run inside the tubing of outer roll bar. From very back, in front of engine, to the front. Where the major junction is. Also ran a 10 gage primary power lead. And a extra 14 gage blue wire with in line fuse. Just in case need for some reason. Figured if in there doing it. An extra power couldn't hurt.
Still haven't messed with the back wiring yet. This will still take some time.
The volt gage is pretty cool. Powered it up. Runs 12.4 without engine running. Flip the light bar on, and gage jumps down to 11.8 volt. Nice option to have.
|