I won't have access to the kart for a couple days or I would have just gone and measured the ID and pitch of the existing tie rod. To reiterate, the existing (stock) tie rod is not 7/16-20. Or is it?
This kart project is getting alot more in depth than I was originally expecting. But I'm enjoying it. My son is 4 now so if I do everything right it will definitely pay off down the road.
[edit]
Ckau - I may have found the source of my confusion -
You said you have 1/2" tubing with 7/16" ID. Did you mean 3/4" tubing? I don't see any way to get a 3/8" bung on 1/2" tubing unless you butt-welded it.
Last edited by Pripyat; 10-03-2017 at 11:34 AM.
|