Figure out how wide you want your front track. say the quad with outside to outside of the tires is 48 inches and you want 54 inches. that extra 6 inches is going to come from the split and widen between the a-arm mounts. measure the current distance between the a-arm mounts at the point the rack shaft will sit, add 6, then subtract the amount needed for the clevises, because you want the tie rod inner pivot at that overall new distance. better to give the clevises a little "extra" length so you don't end up in my situation, where i figured it a bit on the tight side.
Last edited by x-bird; 12-22-2016 at 07:09 AM.
|