The wires in question were from the pigtail on the solenoid I have 2 wires yellow w red stripe and yellow with green stripe.
Ran wires as follows Yellow with green strip went to ground.
Yellow with red stripe went to momentary on 3 wire key switch.
Ground to on side of on for key switch and hot through fuse to other side of on for key switch.
I suppose I could cap and not use the pig tail at all and just run one wire from each post on the top of the solenoid to on and momentary. So when the key was turned to start it would have the same effect as jumping the solenoid. But this is assuming that I haven't damaged the key switch.
__________________
Where there is a red neck there is a way.
Last edited by plee911; 08-06-2018 at 12:52 AM.
|