Piece of cake. First make sure engine is cold since valves are adjusted cold and not after engine has been run.
A). Remove valve cover.
B). Remove fan cover, right side of engine, 2 screws & 2 bolts
C). Turn by hand clockwise via fan until the T on flywheel lines up with pointer on case
D). Observe cam for large hole to point strait at seat and lhash lines on cam sprocket are paralel with top of head. If cam is not in this position with engine at tdc on crank than rotate clockwise again to tdc on flywheel, cam should now be lined up as well.
E). With a .003 feeler gauge check the intake valve (top) adjust until snug fit of gauge.
F). With a .005 feeler gauge check the exhaust (bottom) and repeat step E.
Valves are now adjusted. First time may take one hour but after a few times it should only take 10 - 15 minutes. TOM
|