[OLDKID]

Heck yea , receiver mount . You wouldn't have to use a 2" , but the smaller one with a plate welded on for the winch , and control box . Short length of square tubing front and back of each machine , hitch pin , plug like on a snowplow quick disconnect and away you go ! Watch it though I have same winches front and back on my King Cobra , and one on the back of the Magnum . You have to wire the power supply wires to a key'd or on - off switch power source , or simply disconnect one of the battery leads when not in use . That remote box constantly draws small amount of current , and will drain the battery in a week or less . I ran straight to the battery , simply welded a dime size washer to a battery bolt , spade end connector on the red battery lead . When done for the day - just reach down give the " wing nut " a turn , power cable slides off , and tighten wing nut . Or you'll lose it on the trail , Been there , done that .