My 500cc Crossfire
Just replaced the transmission because I wasn't told that the tranny was toast when I bought it for $275, just that it needed a battery and a chain. The sprockets are out of alignment so will be trying to figure out how to align them since the engine is as far towards the center as it will go because the oil pan hits the angle iron welded to the frame. I really don't want to use a jack shaft. I might have to notch the wide angle iron to gain the 3/4" I need for proper chain alignment. I put a new 8 gal. gas tank on it and a couple other cool features so far. Going to look into fenders soon. Sure wish there was a way to slide my axle over 3/4". Thanks.
|