Yep, that's what I was thinking, I know trying to find or make a spacer for the center is going to be a pain, but the benefit will be worth it. The next challenge will be keeping it centered so that when you go to slide the spindle axle through the hub it will slide through the spacer too.
I have a couple 1.5" 5/8ID spacers laying around I'm gonna try and make something work out of them if I can.
__________________
T.J.
Yerfdog Spiderbox, Uni Type air filter with 6" intake, 130 jet, Orange no-rev limit cdi, Red coil, iridium plug, 1500rpm clutch springs, 1500rpm contra spring, 13g sliders, 22" rears, 21" fronts, aftermarket reverse installed, and Trailtech Vapor.
|