Great, thank you.
I have to look at the tach I used because I think it was set up for a 2 stroke. It said I was only doing 4000 RPM at the end of my top speed run. But I could hear she was wound up pretty good. So prob closer to the 8000 RPM range then.
I need to pull some RPM out of it.
If the wider spreading driven pulley (KNM performance) doesn't do it, I'll prob be looking into going with the 14/38 internal gears as opposed to my stock 13/40.
__________________
My Yerban assault vehicle: 2.2mm stroker crank, 62mm Nikasil cyl, Taida large vavle head, American made valve springs, ported intake manifold, TM 28mm carb, stock CDI, Bando coil, TK exhaust, stock CVT except for the 14g sliders, 13/40 internal gears, 16T drive, 31T axle sprocket, 22" rear tires, and ONE BIG POTATO CANNON mounted on top..........
|