Making new hammerhead harness
ok any one good with electrical work please chime in. I posted under ckau's thread also but I figure while I wait for his response make a thread under electrical. Researching and trying to figure out how im going to finish building the hammerhead wiring harness I was going to go either 6 position or 8 position power fuse.
http://www.delcity.net/store/ATC-&-A...ng-Pad/p_11262
and then I would get 15 amp fuses
http://www.delcity.net/store/ATO®-S...Fuses/p_800317
heres some pics of my wiring harness the stock wiring is just a mess once balled up in the little box. plan is to clean it up so everything has its own power and ground. This is also going to be nice because with the the power position strip I can wire the trail tech for straight power and power the wideband. Im trying to figure out if I do this also can I delete the relay that the stock harness has.
I should have the engine mounted in tomorrow that way I can see where I want to mount the box and how I want to run the wires.
__________________
Hammer head Single seater know as herbie
under construction
Aluminum fuel tank, aluminum wheels, custom fuel/cargo rack, entire rewire, trail tech vapor, ported big valve head, a12camshaft, 12 gram sliders, straight intake, kirkey wide seat, front end extension. 4 point harness, welded cage. Hammerhead exhaust.
Blade Single Seater Restore
welded cage, engine build, new wiring harness/electric box, spun aluminum fuel tank.
|