Know above is an older post, but very helpful. Can anyone suggest what type (model / size) of slide hammer is used to pull these bearings ? Like above, encountered some bearing creaking upon new buggy delivery. We cleaned & repacked bearings - much improved, but from metal shavings in bearings (visible when we cleaned out) we know we will be replacing bearings soon. As above - would like to pull both sides without full disassembly of rear axle, sprocket, disk, if that is possible. Have used pullers before, but would appreciate any tips on the length (reach) of the puller that can be used to remove the bearings - prefer screw type puller (bolt against end of axle) - but is there is a model of slide hammer puller that will work, I'd consider.
My setup exactly like WildBob's pics above.
Thanks !
|