The green and orange wire are for the pulse generator/exciter for the pulse/fire signal, according to the diagram you posted. It is an AC fired unit, but you have me thoroughly confused on the CDI pinout. I will attempt to replicate the position of the CDI, but bear with me.
bottom r/h corner should be kill switch- blk/yellow
bottom center is coil- blk
bottom l/h is pulse- orange or green, this part stumps me....
top r/h is AC power- blk/rd
other 2 pins are grounds
The pulse coil confuses me, it looks to me the CDI supplies the ground for the pulse, might try grounding the green wire to frame first and see if you have fire, then switch. I am confident you can make this thing run on a GY6 CDI. I would be willing to say you could hook up the ground side of the pulse coil to the other side of the CDI, but wait till you get it figured, at the risk of popping another CDI.
__________________
ASE Master and Toyota Master Diagnostic Certified
Buggy Building Trainee
'04 Dazon Raider 150 'modded'
|