I decide to start this thread on the ASW exhaust gut since I didn't find any info specific to my machine's muffler insides.
I wanted some more flow, so originally I just removed end cap and drilled 3 additional holes.
It didn't really give me the results I had hoped for. It did just let a small amount more of exhaust escape and I had a little more noticeable difference in sound.
After asking questions
, reading info, and taking advice I decide to go forward with the gut.
after removing muffler and heat shield I drew and numbered 4 lines on it to help me realign it properly when it is time to weld back together.
I then used my angle grinder and cut behind the end cap; right behind manufacture weld. This is what the inside looks like so far. Just a restrictor plate.
I will continue the project later and document it for those who need. Kids are whining