A guy named Donnie had this made for his CB400A hammerhead swap and I had been talking to him back in january about his build and he said he would have one built for me whenever i got ready but when i emailed him a few months later about it again his wife informed me that he had passed away
.
He said he had the reverse shaft cut down a couple of inches and he had the 1" shaft bored and the the reverse shaft pressed in, trued and welded.....Now whats confusing me is in the finished pictures it appears that its pressed almost to the splines so im assuming that the larger part of the reverse shaft was turned down?Also see no sign of being welded and in the drawings hes got the shaft listed as 3/4 but his parts list all showed 1" stuff. What are your thoughts on this?
P.S. Fan4chevy not trying to hijack your thread but maybe this will help you out also if you decide to go this route