Wiring harness from front reads as follows.
Solid yellow wire----Light Switch
Solid Black wire ----Speedo, Ignition switch, Brake switch
Solid Brown wire----Light switch,Speedo
Solid Green wire----Kill Switch,Speedo,Ignition
Solid Red wire ----Ignition switch
Yellow-Red stripe wire----Ignition switch
Green-White stripe wire----Speedo
Green-Yellow stripe wire----Brake switch
Black-White stripe wire----Kill switch,Ignition switch
On the back side what should these wires connect to?
Oh! not to question you but that's the resistor from manufacture, wouldn't they send two wire resistor if that's what was needed for this setup?
Not sure what a solder bump is,so i don't know if that's one or not
Last edited by stewdog259; 06-16-2012 at 01:19 AM.
Reason: Addition
|