View Single Post
  #37  
Old 10-22-2015, 08:08 AM
tkeagle tkeagle is offline
Heavy Contributor
 

Join Date: Mar 2015
Location: Central Kansas
Posts: 556
Default

finally got the seat bracket off. OMG, talk a about an over kill. Finally had to just cut on the upper side of where the bracket is welded to. Then come back and remove bracket pieces that was welded to the frame. Just not enough room to get a cutting wheel in there. Even a dremel had a problem getting in a few spots.
Now need to clean up where the wheel cut into the frame, Fab up some replacement pieces that I cut off, and weld it into the correct location for the new seat.
Didn't think would be such a pain. Might have just went back to stock seat, if known been this much work. But new seat, if far better. Not sure worth the work thou.
Reply With Quote