View Single Post
  #1  
Old 04-01-2016, 11:36 AM
WizardMaster's Avatar
WizardMaster WizardMaster is offline
Lurker
 

Join Date: Jan 2016
Location: Palm Coast FLA
Posts: 16
Default My 500cc Crossfire

Just replaced the transmission because I wasn't told that the tranny was toast when I bought it for $275, just that it needed a battery and a chain. The sprockets are out of alignment so will be trying to figure out how to align them since the engine is as far towards the center as it will go because the oil pan hits the angle iron welded to the frame. I really don't want to use a jack shaft. I might have to notch the wide angle iron to gain the 3/4" I need for proper chain alignment. I put a new 8 gal. gas tank on it and a couple other cool features so far. Going to look into fenders soon. Sure wish there was a way to slide my axle over 3/4". Thanks.
Attached Images
File Type: jpg NEWduneBUGGYphotos 027.jpg (96.6 KB, 30 views)
File Type: jpg NEWduneBUGGYphotos 067.jpg (101.4 KB, 34 views)
File Type: jpg NEWduneBUGGYphotos 068.jpg (99.9 KB, 32 views)
File Type: jpg DuneBuggyEngineREBUILD 293.jpg (95.0 KB, 28 views)
File Type: jpg DuneBuggyEngineREBUILD 171.jpg (94.3 KB, 30 views)
Reply With Quote