View Single Post
  #3  
Old 05-24-2017, 10:17 AM
Christof13T Christof13T is offline
Lurker
 

Join Date: May 2017
Posts: 17
Default

I'm not terribly interested in a body swap with donor guts. Still not quite sure how far I want to go with this thing. I like the idea of just building a new pan on this frame. its not that bad of a job once I clean up around where everything rusted off...

So far i have freed up the steering and have it functioning acceptably...
Freed up and cleaned the carb...
checked compression (155psi)

I am now checking through the electrical system and running into walls.
are the electrical specs for all the gy6 150cc motors round about the same?
wanna check the stator, coil, starter solenoid, rectifier, cdi...
what resistance should the bar resistor be?
Looking at the wiring, the bar resistor seems to control electric choke?

ignition circuit...
which 2 are ignition circuit on, and which one is solenoid signal?

I know for sure I am going to have to repair ALL of the grounds on this rust monster.

pictures...
does this site prefer external links or direct uploaded images?
Reply With Quote